swr fittings

87.5 Deg. Bend & Door Bend – 87.5 deg. Bend provides turns to a pipe wherever it is required. In case of Door bend it has a special inbuilt door which can be used to inspect & clean the choke up dirt or waste in Drainage Pipes.

45 Deg. Bend – This Drain Pipe Fitting is used to bend a straight coming pipe to an 45 degree angle in any direction.

87.5 Deg. Plain Tee & Door Tee- It has two inlets to receive 2 different fluids and pass through only outlet to main sewage. In case of Door Tee it has a special inbuilt door which can be used to inspect & clean the choke up dirt or waste in Drainage Pipes.

Cleaning Pipe- used for drainage systems which has an especially inbuilt door helps cleaning in any case of choke of dirt and waste.

Single Y & Door Y- Single Y is similar to Single Tee only. It has 2 inlet and 1 outlets, In case of Door Y in SWR FITTING helps the cleaning of Drainage Pipes easily.

Coupler- This SWR FITTING helps join pipe to pipe straight.
Cross Tee & Cross Tee With Door- It has 4 channels that could be used to 3 inlets and 1 outlet, used for drainage fitting.

Double Y & Double Y With Door- Double Y is used to have 3 inlets and 1 outlet, In case of Double Y with door help inspecting & cleaning of clogging.

Ecc Reducer- it is used to reduce the size of pipe in this connection. Reducer is a sophisticated part of SWR Fittings, Drain Pipe Fittings, Drainage Fittings, Sanitary Pipe Fittings, Sewage Pipe Fittings.

SWR Pipe clip- It used to fix the SWR Pipe in its place to avoid damaging the drainage system due to dislocation of pipe and fitting while flowing waste.

Door cap- it used to shut the access hole of Door type SWR Fittings, Drain Pipe Fittings, Drainage Fittings, Sanitary Pipe Fittings, Sewage Pipe Fittings for preventing the spillage.

Vent Cowl- It is used for stopping dirt and waste from outside to air vent and helps to allow fresh air to the drainage system to neutralize the negative pressure created inside the drainage system when it is in use.

P/S/Q Trap- These traps are used in indian waste disposal systems to clear out solid waste. It has a water seal which helps to prevent bad odour to enter into the building.

Nahani Trap- Nahani trap is used to collect surface water and transfer it to waste pipe. It has a water seal which helps to prevent bad odour to enter into the building.

Multi Floor Trap- MFT has three inlet and one outlet. It receives waste water from 3 different sources and transfers it through the outlet to the waste pipe. It comes with a partition which helps to create water seal to prevent bad odour from entering the building and also it helps to hold solid waste at the bottom of the trap which can be cleaned from time to time by taking out the partition.